Practical ideas from FARM SHOW MagazineSubscribe · Free issue · Send us your shop tip
Subscribe to FARM SHOW
Home / Vol. 20, No. 2 (1996)

Glen Libbrecht

Glen Libbrecht, West Fargo, N.Dak.

“The original U-joint on my Deere 4850 tractor with mechanical front-wheel drive was wearing down the splined transmission shaft. To prevent further wear, a local welding shop disassembled the U-joint and cut the old yolk off. A slip yoke was welded in to allow for some movement in the driveline. The remaining yoke had two bushings welded on and then was cut so it could be clamped to the drive shaft. Now the small amount of play needed in the driveline is in the slip yoke and not wearing the transmission shaft. The repair cost about $232 but replacing the transmission shaft would have cost a lot more. I’ve used it this way for about three years with no problems.”

Reproduced from the published FARM SHOW entry. Prices, coupons, availability and contact details are historical, not current offers. Reader methods are not universal instructions: follow manufacturer guidance, proper supports and safety practices, and consult a qualified professional when needed.

Comments and votes

Have you tried this idea? Mark it helpful and share how it worked in your shop.