Practical ideas from FARM SHOW MagazineSubscribe · Free issue · Send us your shop tip
Subscribe to FARM SHOW
Home / Vol. 20, No. 2 (1996)

Charlie Reich

Charlie Reich, Grants Pass, Ore.

“If you have an old “N” Ford tractor that’s having hydraulic lift problems, here’s how to check it out. Take off the left inspection cover. It’s the one that contains the pto lever. Start the tractor and make sure the pto is turning, indicating the pump is operating. Now lay on your back and look upwards through the opening to observe the lift cylinder and piston. While the pump is running and the lift arms are raised, there should be no oil leakage from around the piston nor should there be any oil coming from around the cylinder itself.

“If there is oil leakage, unbolt and lift off the hydraulic lift cover. That’s the piece the seat bolts to. Upon turning this unit over, you will see the cast iron hydraulic cylinder and piston assembly. There are two minor problems that can occur with the cylinder and assembly: 1. blown gaskets or 2. a leaking piston and worse, a cracked cylinder or a deeply pitted cylinder bore. If the oil was leaking from around the re-taining bolt holes, you probably have some blown gaskets. A complete transmission gasket kit is available for about $12 from Ford.

“Next, you may have to replace the re-lief valve. Grab a big pan or bucket that’ll hold the 5 gal. of transmission oil. After draining the oil, go around to the rear of the tractor and remove the four bolts holding the pto cover and pull out the pto shaft. Now reach down inside the inspection cover opening and unscrew the relief valve. It’s located on the rear of the hydraulic pump just under the (recently removed) pto shaft. If you want to make sure it’s bad, your Ford tractor dealer has a special gauge to test these relief valves. A new relief valve currently costs about $20.

“After installing the new valve, replace the pto shaft and refill with oil. This is a good time to replace the pto shaft seal and install a fresh batch of 90W gear lube.

“This repair will let your old “N” lift and hold like she used to. It’ll be good for another 50 years.” (Reprinted courtesy 9N-2N-8N-NAA Newsletter, P.O. Box 235, Chelsea, Vt. 05038)

Reproduced from the published FARM SHOW entry. Prices, coupons, availability and contact details are historical, not current offers. Reader methods are not universal instructions: follow manufacturer guidance, proper supports and safety practices, and consult a qualified professional when needed.

Comments and votes

Have you tried this idea? Mark it helpful and share how it worked in your shop.