“The remote control I built for my Lincoln 275 amp hand-cranked stick welder back in 1950 has saved me a tremendous amount of time because I don’t have to run back and forth to my welder to turn heat up and down. It would probably work just as well on some newer welders.
“It consists of a gear reduction box and a small electric motor that mounts on back of the welder.
“The add-on gear reduction box chain drives the welder’s drive shaft with a # 50 roller chain.
“A 30-ft. length of 3/8 in. dia. cable connects the electric motor with a 1 by 3-in. hand-held control box. To increase heat, I simply toggle the switch on top of the control box forward and toggle it backwards to decrease heat.
“I’ll make plans available if there’s enough interest. I’m at P.O. Box 156, Neosho, Wis. 53059-0156 (ph 414 625-3451).”
Reproduced from the published FARM SHOW entry. Prices, coupons, availability and contact details are historical, not current offers. Reader methods are not universal instructions: follow manufacturer guidance, proper supports and safety practices, and consult a qualified professional when needed.
Comments and votes
Have you tried this idea? Mark it helpful and share how it worked in your shop.