Practical ideas from FARM SHOW MagazineSubscribe · Free issue · Send us your shop tip
Subscribe to FARM SHOW
Home / Vol. 20, No. 3 (1996)

Heavy Duty Rolling Shop Crane

Featured source:

“My homemade shop crane makes it easy and safe to move heavy loads virtually anywhere inside my shop,” says Daryl Scheer, Mapleton, Iowa. The frame of the 4-wheeled crane was built from scrap steel. It’s equipped with a 3-ton chain hoist that rolls back and forth on the top I-beam. Both ends of the crane mount on wheels so it can be rolled anywhere in the shop.

“It’s one of the handiest tools in my shop,” says Scheer.

“I looked at commercial shop cranes and the more I looked, the more I decided that I could build my own. It’s 16 ft. wide and 14 ft. high but can be raised or lowered by jacking it up and changing the position of a pin in each leg. I’ve even used it to pull cabs off tractors.”

The sides are made from 4 by 7-in. steel tubing salvaged from the frames of old row crop cultivators and the top is made from a 4 by 8-in. steel I-beam salvaged from an old bridge. He useed 2 1/2-in. sq. steel tubing to make corner braces and 4-in. dia. pipe to make the legs.

Contact: FARM SHOW Followup, Daryl Scheer, 310 S. 8th St., Mapleton, Iowa 51034 (ph 712 882-1439).

Reproduced from the published FARM SHOW entry. Prices, coupons, availability and contact details are historical, not current offers. Reader methods are not universal instructions: follow manufacturer guidance, proper supports and safety practices, and consult a qualified professional when needed.

Comments and votes

Have you tried this idea? Mark it helpful and share how it worked in your shop.