Practical ideas from FARM SHOW MagazineSubscribe · Free issue · Send us your shop tip
Subscribe to FARM SHOW
Home / Vol. 20, No. 4 (1996)

“Pin Eliminator” Solves 3-Pt. Problems On Magnum Tractors

Featured source:

The 3-pt. hitch on popular Case-IH Magnum tractors is controlled by a set of load sensing pins. Jay Bottolfson, Vermillion, S. Dak., had problems with the pins so he came up with a modification kit called the “Pin Eliminator”.

“It bypasses the original load sensing pins,” says Bottolfson.

“The pins often fail. I got the idea one day last fall while V-ripping with my Magnum and a pin went bad. Whenever this happens, control of the 3-pt. becomes so erratic as to make it unusable. This was the third pin I had replaced on the tractor which has otherwise been totally reliable. The pins sell for about $500 apiece, but since I don’t even use the draft control on the tractor, I decided to eliminate the problem for good.“ “I contacted my cousin, an electronics engineer with 20 years of experience, and together we developed an electronics module that eliminates the pin function from the system altogether.”

Here’s how it works. Unplug both sen-sor pins from plug-ins at the back of the tractor and plug in a Pin Eliminator on each side in place of the sensor pin wire.

“Because it uses miniature electronic components, the Pin Eliminators are small and out of the way,” says Bottolfson.

“At $149 per pair, they save you about $350 over the cost of one pin and $850 over the cost of a set. You won’t have any more load sensing pin problems for the life of the tractor, and it comes with a 1-year replacement warranty.”

Dealer inquiries invited. Contact: FARM SHOW Followup, Jay Bottolfson, B & L Electronics, Rt. 1, P.O. Box 143, Vermillion, S. Dak. 57069 (ph 605 670-1796).

Reproduced from the published FARM SHOW entry. Prices, coupons, availability and contact details are historical, not current offers. Reader methods are not universal instructions: follow manufacturer guidance, proper supports and safety practices, and consult a qualified professional when needed.

Comments and votes

Have you tried this idea? Mark it helpful and share how it worked in your shop.