Charles built a hydraulic shop press that attaches to a punch press so he could repair the housing on his 27 1/2-ft. 4153 Will Rich air seeder.
“I’ve never seen a commercial hydraulic press that can be locked so precisely in place,” he says.
“I built a rigid frame out of 3 by 5-in. tubing and used 1/2 by 3-in. flat bar steel for uprights so there’s absolutely no play in the columns. I mounted a Williams four-piston hydraulic pump off a grain truck hoist on top of the 8-ft. high upside down A-frame, which is trussed on top. I use a 1 1/2 hp electric motor to drive the pump, which connects to a hydraulic cylinder I made myself. The cylinder, which will accommodate punch sizes up to 1 1/4 in., can be adjusted from side to side with C-clamps. This way I can vary spacings of holes. I used 7-in. heavy wall channel iron to make the pressing bed. I made a 10 by 12-in. die plate out of 1-in. T #1 steel to adapt the press to punching steel.
“The unit mounts on a two-wheel cart fitted with 400 by 8 in. lawn mower tires so I can push it around my shop or even use it as far outside as an extension cord will reach.
“I haven’t tested its full capacity, but I’ve punched 1 in. dia. holes in steel plate up to 1/4-in. thick with it. My guess is that this job required only about half of the pump’s 3,500 psi capacity.”
Reproduced from the published FARM SHOW entry. Prices, coupons, availability and contact details are historical, not current offers. Reader methods are not universal instructions: follow manufacturer guidance, proper supports and safety practices, and consult a qualified professional when needed.
Comments and votes
Have you tried this idea? Mark it helpful and share how it worked in your shop.