Practical ideas from FARM SHOW MagazineSubscribe · Free issue · Send us your shop tip
Subscribe to FARM SHOW
Home / Vol. 22, No. 3 (1998)

Ryan Feige

Ryan Feige, Astoria, S. Dak.

“Two years ago I bought a Deere 4010 tractor equipped with a bad diesel engine for $2,500. The 6-cyl. engine had about 10,000 hours, used oil, and also needed head and injector work. I replaced it with a 6-cyl. turbocharged diesel out of a Deere 7700 combine. It was equipped with a big Bosch fuel injection pump and a water pump that’s bigger than the one on the original 4010 engine (older 7700s were equipped with a smaller Rosamaster injection pump and a smaller water pump just like on 4010s).

“To overhaul the original engine would’ve cost $3,000 to $3,500. It had 380 cu. in. and wasn’t turbocharged. The new engine has 404 cu. in and is turbocharged, giving it 140 hp compared to 80 before. There’s no visual difference but the tractor has a lot more power. Also, the new engine has only about 3,500 hours so it’s almost like starting out with a new engine. I paid $2,100 for the engine. I’d do the same thing again without hesitating.

“I borrowed the frame rails from a Deere 4320 tractor to make room for the fan on the new engine’s water pump. I had to lengthen the hood 4 in. so that the turbocharger would fit and also put in a new clutch and bell housing. The bell housing bolted right up.”

Reproduced from the published FARM SHOW entry. Prices, coupons, availability and contact details are historical, not current offers. Reader methods are not universal instructions: follow manufacturer guidance, proper supports and safety practices, and consult a qualified professional when needed.

Comments and votes

Have you tried this idea? Mark it helpful and share how it worked in your shop.