Practical ideas from FARM SHOW MagazineSubscribe · Free issue · Send us your shop tip
Subscribe to FARM SHOW
Home / Vol. 22, No. 3 (1998)

Jack Dyck

Individual tip 2 of 2 from this reader’s published contribution.
Jack Dyck, Richmond, B.C.

“I also made my own pressure washer that’s powered by the engine off a 1962 Volkswagen Beetle car. I removed the clutch plate from the flywheel and filled in the center of the clutch with a small steel plate, then drilled holes into the plate and bolted on a 3-groove pulley. The pulley, covered for safety, belt-drives a Giant pump that I bolted onto a steel bracket. I bolted half of a VW transmission case to the engine block (the early VW transmissions were built in two pieces) and bolted an 8-in. channel iron bracket onto the transmission in order to mount the pump. Water travels from the pump through steel hydraulic hoses and into a wand (not shown). I knocked the valves out of the connectors on the hoses so that they’re totally open.

“The original VW fan housing is still used to cool the engine. I didn’t change anything on the housing except to close some ducts in order to get more air to the engine. I mounted a pair of switches on the housing. One is the ignition switch (the transmission contains the engine’s starter mounting) and the other activates an automatic throttle that I made. The throttle is a flow switch that’s activated by flowing water - it closes a relay which ener-gizes an electromagnet on the throttle. It always keeps the engine running at idle until I pull a trigger on the wand - then it will rev up the engine to its pre-set maximum. As soon as I let go of the throttle switch the engine returns to idle.

“The pump bracket has slotted holes for adjusting belt tension. I just loosen a bolt to adjust the tension.

“The fuel tank is from an outboard motor. I use an automotive electric fuel pump to supply the carburetor with fuel. The pump is wired into the ignition switch so that whenever the ignition is on, the pump is working.

“I’m semi-retired but have started a pressure washing business. I use my homemade pressure washer to clean houses, driveways, sidewalks, etc. I even use it to wash restau-rants. It mounts in the back of my pickup.”

Reproduced from the published FARM SHOW entry. Prices, coupons, availability and contact details are historical, not current offers. Reader methods are not universal instructions: follow manufacturer guidance, proper supports and safety practices, and consult a qualified professional when needed.

Comments and votes

Have you tried this idea? Mark it helpful and share how it worked in your shop.