Practical ideas from FARM SHOW MagazineSubscribe · Free issue · Send us your shop tip
Subscribe to FARM SHOW
Home / Vol. 23, No. 1 (1999)

Low-Cost All-In-One Metal Fabricator

Featured source:

“Comparable machines cost four times as much,” says Mike Nimmo about the “All-In-One Fabrication Shop,” a compact metal-working tool with 40 tons of power.

Powered by a 110-volt 3/4 hp motor, it can punch, shear, notch, bend, form and press.

The shear can handle flat, round, square and angled steel up to 3/8-in. thick and can be switched to an 8-in. brake that’ll bend steel up to 1/4 in. thick.

The 40-ton punch has a 3 3/4-in. deep throat and can punch a 1-in. dia. hole in 3/8-in. steel. It’s capable of four to six strokes per minute.

Options include a variety of punches and dies, a heavy-duty notcher attachment and a pipe notcher.

Sells for under $2,500. Contact: FARM SHOW Followup, METALpro Ironworkers, 1320 Plainfield Avenue, Janesville, Wis. 53545 (ph 800 558-1345 or 608 758-1345; fax 1272).

Reproduced from the published FARM SHOW entry. Prices, coupons, availability and contact details are historical, not current offers. Reader methods are not universal instructions: follow manufacturer guidance, proper supports and safety practices, and consult a qualified professional when needed.

Comments and votes

Have you tried this idea? Mark it helpful and share how it worked in your shop.