Practical ideas from FARM SHOW MagazineSubscribe · Free issue · Send us your shop tip
Subscribe to FARM SHOW
Home / Vol. 24, No. 1 (2000)

Ron Saltzman

Individual tip 1 of 2 from this reader’s published contribution.
Ron Saltzman, Corning, Iowa

“I used sheet metal to make a 2-ft. long funnel that bolts onto the end of my grain auger. Grain was splattering off a flipper at the end of the auger and, if it was windy, some of it blew away before reaching the truck. The funnel makes the grain flow straight down.

“I made a pattern in the sheet metal, cut it out, and pop riveted it together. I bolted a pair of small steel tabs onto the auger and drilled a hole through each one. A steel rod goes through both brackets and is secured by a cotter pin. I bolted a small wooden block onto each side of the funnel to keep the rod from wearing through the metal.

“I made two of these funnels, one on an auger that I use to fill my dryer bin and the other on a transport auger that I use to load trucks. The rod is off an old wagon box. My only cost was for the sheet metal which I bought at a plumbing store.

Reproduced from the published FARM SHOW entry. Prices, coupons, availability and contact details are historical, not current offers. Reader methods are not universal instructions: follow manufacturer guidance, proper supports and safety practices, and consult a qualified professional when needed.

Comments and votes

Have you tried this idea? Mark it helpful and share how it worked in your shop.