Practical ideas from FARM SHOW MagazineSubscribe · Free issue · Send us your shop tip
Subscribe to FARM SHOW
Home / Vol. 24, No. 4 (2000)

Robert E. Sanner

Robert E. Sanner, York, Neb.

“To replace U-joints on ag power shafts and some automotive shafts, I’ve found a conventional vice works best. I made this tool that hangs on a vice and leaves both hands free. It consists of two pieces of strap iron 5 in. long by 1 in. wide. You bend them over with a hammer to fit the jaws of the vice. Then weld a 1 1/4-in. nut on one side and a 3/4-in. dia. by 1/2 in. long rod on the other side. It works best to put the nut on the front side of the vice. I’ve never seen a tool like this in any service catalog but it works good.”

Reproduced from the published FARM SHOW entry. Prices, coupons, availability and contact details are historical, not current offers. Reader methods are not universal instructions: follow manufacturer guidance, proper supports and safety practices, and consult a qualified professional when needed.

Comments and votes

Have you tried this idea? Mark it helpful and share how it worked in your shop.