Practical ideas from FARM SHOW MagazineSubscribe · Free issue · Send us your shop tip
Subscribe to FARM SHOW
Home / Vol. 26, No. 5 (2002)

Donald Winkler

Donald Winkler, North Platte, Neb.

“Our oldest son bought a used arc welder from the maintenance department of a local factory. It was a large D.C. welding generator driven by a 220-volt, 3-phase A.C. motor. They sold it cheap because it didn’t work properly. The problem was that the company had crossed the 220-volt input wires, which caused the armature to run backward. As a result it wouldn’t excite the generator fields. They tried using a car battery to excite the generator. This caused the generator to produce a D.C. welding current, but because the armature was rotating in the wrong direction, the commutator brushes arced terribly.

“Our son, John, pulled the A.C. motor armature off the common shaft that it shared with the D.C. armature. Then he coupled the shaft to a 4-cyl. Jeep engine and mounted everything on a 4-wheel trailer. The result is a portable gas-driven, D.C. welder. It has a lot of power and runs a strong, smooth bead.”

Reproduced from the published FARM SHOW entry. Prices, coupons, availability and contact details are historical, not current offers. Reader methods are not universal instructions: follow manufacturer guidance, proper supports and safety practices, and consult a qualified professional when needed.

Comments and votes

Have you tried this idea? Mark it helpful and share how it worked in your shop.