Practical ideas from FARM SHOW MagazineSubscribe · Free issue · Send us your shop tip
Subscribe to FARM SHOW
Home / Vol. 26, No. 5 (2002)

Kenny Brandt

Kenny Brandt, 32748 I. Ave., Hubbard, Iowa 50122 (ph 641 864-3283)

“My John Deere B loader tractor, which is equipped with a narrow front end, steered hard. The conventional way to add power steering would have been to add a power steering pump and belt-drive it by adding a double pulley to the fan shaft. But to do that I would have had to remove the gas tank and radiator.

“Instead I replaced the original generator with a 12-volt alternator and mounted a double-grooved pulley on it. I went to a junkyard and found an old Pontiac power steering pump, which I mounted on the opposite side of the tractor using homemade brackets. It drives off the alternator. Then I mounted a Charlin hydraulic motor on the tractor’s steering shaft, just in front of the steering wheel. I drilled a hole through the steering shaft and bolted the motor to it.

Hydraulic hoses run from the pump to the motor.

“I bought the pulley new and spent about $25 on belts. I already had the Charlin hydraulic motor. My total cost was only about $75. Now I can steer the tractor with just one finger, even with a load on it.

“

Reproduced from the published FARM SHOW entry. Prices, coupons, availability and contact details are historical, not current offers. Reader methods are not universal instructions: follow manufacturer guidance, proper supports and safety practices, and consult a qualified professional when needed.

Comments and votes

Have you tried this idea? Mark it helpful and share how it worked in your shop.