Practical ideas from FARM SHOW MagazineSubscribe · Free issue · Send us your shop tip
Subscribe to FARM SHOW
Home / Vol. 26, No. 6 (2002)

Charles Hoyt

Individual tip 2 of 2 from this reader’s published contribution.
Charles Hoyt, Medina, Ohio

“I made my own wood burning stove and mounted a heat exchanger inside the stove pipe. I use it to heat my 32 by 28-ft. shop building which has an 11-ft. high ceiling, as well as a 12-ft. wide, 28-ft. long area where ductwork from the furnace goes. The stove is hooked up to a 100,000 btu fuel oil furnace in my shop and automatically shuts the furnace off to save on fuel bills.

“The heat exchanger was made from an old freon tank which I got from a neighbor. I cut the tank down and lined it with firebrick to make it airtight, then mounted the milk cooler fan on the back side of it. I put a nipple on the bottom and top of the unit. Heat coming up from the stove goes around inside the freon tank and out the stove pipe. A thermostat switch is wired to the smokestack so as soon as the smokestack gets hot it turns the milk cooler fan on.

“To heat up my shop, first I start up the fuel oil furnace. Then I start building up a fire in the wood stove. Once the fire gets going good, it’ll automatically shut off the furnace.”

Reproduced from the published FARM SHOW entry. Prices, coupons, availability and contact details are historical, not current offers. Reader methods are not universal instructions: follow manufacturer guidance, proper supports and safety practices, and consult a qualified professional when needed.

Comments and votes

Have you tried this idea? Mark it helpful and share how it worked in your shop.