Practical ideas from FARM SHOW MagazineSubscribe · Free issue · Send us your shop tip
Subscribe to FARM SHOW
Home / Vol. 27, No. 6 (2003)

Bruce Graham

Bruce Graham, Tyler, Texas

“Not long ago I stripped out a thread where a flywheel bolts onto the crankshaft of an engine. I didn’t want to have to pull the engine again in order to fix the threads, but I was concerned about tapping a thread insert into it without a proper alignment tool.

“To solve the problem, I took a piece of a 2 by 4 and made a guide bushing out of it by drilling it to the tap drill size on my drill press. I also located and put two additional holes in it to bolt it to the hub. Then I drilled the stripped hole with the proper tap drill for the helicoil insert, using the wood block to guide it. I was able to make a perfectly tapped hole in the motor. This idea can be used any time you have a stripped-out hole where a piece of wood can be bolted or clamped over it.”

Reproduced from the published FARM SHOW entry. Prices, coupons, availability and contact details are historical, not current offers. Reader methods are not universal instructions: follow manufacturer guidance, proper supports and safety practices, and consult a qualified professional when needed.

Comments and votes

Have you tried this idea? Mark it helpful and share how it worked in your shop.