Practical ideas from FARM SHOW MagazineSubscribe · Free issue · Send us your shop tip
Subscribe to FARM SHOW
Home / Vol. 28, No. 2 (2004)

Rotating Shop Hoist

Featured source:

“I built it to save my back,” says George “Bing” Ribble about an easy rotating shop hoist he uses to move heavy loads of a ton or more into and out of his shop.

The Hettick, Ill., farmer used two different sizes of heavy duty well casing for the 11-ft. high upright anchored just inside the door of his shop. The outer pipe is 8 in. in dia.; the pipe that rotates inside is 7 1/2 in. in dia.

The outer pipe is sunk in 3 ft. of concrete in the floor of the shop. The inner pipe mounts on a bearing hub out of a disk gang to make it rotate easily, with only a nudge. A race mounts on top of the bearing, helping to take weight off the inner well casing.

Three bearings at the top mount in brackets in a notch in the outer pipe to keep the inner pipe centered.

The lift arm consists of a 10-ft. I- beam. It’s fitted with a shop-built carrier that runs in five bearings out of an old corn picker head. A commercial chain hoist mounts in the carrier.

“The hoist rotates 220 degrees at the touch of a finger and works great for moving heavy objects, such as engines, into and out of my shop,” says Ribble.

“It’s a lot handier than using a front end loader or backhoe as we did before.”

Out-of-pocket expense was about $100. Contact: FARM SHOW Followup, George “Bing” Ribble, Rt. 2, Hettick, Ill. 62649 (ph 618 778-5752).

Reproduced from the published FARM SHOW entry. Prices, coupons, availability and contact details are historical, not current offers. Reader methods are not universal instructions: follow manufacturer guidance, proper supports and safety practices, and consult a qualified professional when needed.

Comments and votes

Have you tried this idea? Mark it helpful and share how it worked in your shop.