Practical ideas from FARM SHOW MagazineSubscribe · Free issue · Send us your shop tip
Subscribe to FARM SHOW
Home / Vol. 28, No. 4 (2004)

Everett W. Gustafson

Individual tip 1 of 2 from this reader’s published contribution.
Everett W. Gustafson, RD 2, Box 349, Brockway, Penn. 15824

“When I had to replace the starter on my John Deere 318, I had to remove the engine since the starter is between the engine and frame.

“There’s not much room to get the drive shaft connected. It keeps falling off the spline at the transmission so it’s difficult to recon-nect the two when putting the tractor back together.

“I solved the problem by cutting a rectangular hole over the drive shaft so I can use a wire or rope to hold the shaft up while I put the engine back in place.

“You have to be careful not to cut off any pipes under the floor when cutting the hole.

“To replace the cover I cut out, I bolted a 1-in. by 1/16-in. piece of aluminum to the cutout piece which holds it in place.

Reproduced from the published FARM SHOW entry. Prices, coupons, availability and contact details are historical, not current offers. Reader methods are not universal instructions: follow manufacturer guidance, proper supports and safety practices, and consult a qualified professional when needed.

Comments and votes

Have you tried this idea? Mark it helpful and share how it worked in your shop.