Practical ideas from FARM SHOW MagazineSubscribe · Free issue · Send us your shop tip
Subscribe to FARM SHOW
Home / Vol. 30, No. 2 (2006)

Splitting A Nut With A Drill

Featured source: Arco Rosenow

Arco Rosenow, Chillicothe, Ill., says you can use a power drill to safely split a stubborn nut off its stud.

“Rather than risk twisting a stud off, or accidentally cracking a casting with a hammer and chisel, I use a power drill with a 1/ 4-in. dia. bit. I clamp another nut against the frozen nut, then center punch into the seam and drill a 1/8-in. dia. hole. I increase the drill bit size until the bit just touches the stud’s threads. Then I use a breaker bar to work the nut back and forth. Once the nut comes loose it tends to work like a thread chaser.

“I usually clean the exposed threads and then apply penetrating oil before I use the breaker bar. If the nut is really stubborn, I repeat the procedure on the other side of it.

“The best thing about this method is that I can still use a socket wrench on the nut,” says Rosenow.

Contact: FARM SHOW Followup, Arco and Judy Rosenow, 1223 Hallock Hollow, Chillicothe, Ill. 62523 (ph 309 274-2107).

Reproduced from the published FARM SHOW entry. Prices, coupons, availability and contact details are historical, not current offers. Reader methods are not universal instructions: follow manufacturer guidance, proper supports and safety practices, and consult a qualified professional when needed.

Comments and votes

Have you tried this idea? Mark it helpful and share how it worked in your shop.