Practical ideas from FARM SHOW MagazineSubscribe · Free issue · Send us your shop tip
Subscribe to FARM SHOW
Home / Vol. 30, No. 3 (2006)

Ken Voigt

Individual tip 2 of 2 from this reader’s published contribution.
Ken Voigt, Wausau, Wis.

“I also made a sheet metal bending brake. The press measures 6 ft. 3 in. wide and can open up to 7 in., which is handy. The top part is made from chopper knives that have the right angle needed for that section. A 1/2-in.

drill, mounted at one end, drives a 1-in. threaded rod one way and then the other. I use a foot switch on the floor to hold the metal with both hands. A chain drive connects the two 1-in. threaded rods at each end so that it opens and closes evenly. The brake is also hinged to the shop wall at one end, allowing me to roll it out of the way whenever it’s not needed.”

Reproduced from the published FARM SHOW entry. Prices, coupons, availability and contact details are historical, not current offers. Reader methods are not universal instructions: follow manufacturer guidance, proper supports and safety practices, and consult a qualified professional when needed.

Comments and votes

Have you tried this idea? Mark it helpful and share how it worked in your shop.