Practical ideas from FARM SHOW MagazineSubscribe · Free issue · Send us your shop tip
Subscribe to FARM SHOW
Home / Vol. 30, No. 6 (2006)

Gordon Black

Individual tip 1 of 2 from this reader’s published contribution.
Gordon Black, 42042 E. Lane 16, Burns, Oregon 97720

“I wanted to cut the lid off a 55-gal. steel barrel, but I was afraid to because I didn’t know what kind of material the barrel originally contained. To solve the problem, I closed the jaws of a pipe wrench just enough to get the jaws over the folded rim of the barrel. Then I used a big hammer to hit the back side of the top jaw until the jaw punched through the barrel. Once I made that initial hole through the rim, I was able to tip the wrench on its side and take half bites with the wrench. I kept tapping the wrench. It shears a clean hole and works better than using a cold chisel, where you risk hurting your hands. It rolls the rim down so there’s no sharp edge sticking up to get cut on.

“You can sharpen the top jaw of the wrench with a grinder to make it cut better. Makes the wrench look funny but it doesn’t affect its usage.

Reproduced from the published FARM SHOW entry. Prices, coupons, availability and contact details are historical, not current offers. Reader methods are not universal instructions: follow manufacturer guidance, proper supports and safety practices, and consult a qualified professional when needed.

Comments and votes

Have you tried this idea? Mark it helpful and share how it worked in your shop.