Practical ideas from FARM SHOW MagazineSubscribe · Free issue · Send us your shop tip
Subscribe to FARM SHOW
Home / Vol. 32, No. 3 (2008)

Gordon Fuller

Gordon Fuller, Barriere, B.C.

“I built a metal brake that’s shown here putting a 90 degree bend in a 1/4-in. thick, 1 1/2-in. wide strap of steel. For the brake’s push bar, I used the 1 by 6-in. cutting edge off a Caterpillar blade, with a 1 1/2-in. angle iron held on with plates and bolts. It pushes into two angle irons that are welded onto the bottom beam to form a ‘V’. The springs from a pickup hood are used to pull and hold it open. I’ve used this brake to bend 1/4-in. thick, 8-in. wide steel with no problems. It works great.”

Reproduced from the published FARM SHOW entry. Prices, coupons, availability and contact details are historical, not current offers. Reader methods are not universal instructions: follow manufacturer guidance, proper supports and safety practices, and consult a qualified professional when needed.

Comments and votes

Have you tried this idea? Mark it helpful and share how it worked in your shop.