Practical ideas from FARM SHOW MagazineSubscribe · Free issue · Send us your shop tip
Subscribe to FARM SHOW
Home / Vol. 33, No. 1 (2009)

Ronald Adams

Individual tip 1 of 2 from this reader’s published contribution.
Ronald Adams, Louisville, Miss.

“I had a bearing on the end of a shaft go bad. The dealer said the machine had to be completely torn down to press it off. Instead, I welded a piece of pipe to the bearing and then welded a flat bar across the end of the pipe. I then used two bottle jacks to pull the bearing off. Took me only about two hours.

Reproduced from the published FARM SHOW entry. Prices, coupons, availability and contact details are historical, not current offers. Reader methods are not universal instructions: follow manufacturer guidance, proper supports and safety practices, and consult a qualified professional when needed.

Comments and votes

Have you tried this idea? Mark it helpful and share how it worked in your shop.