Practical ideas from FARM SHOW MagazineSubscribe · Free issue · Send us your shop tip
Subscribe to FARM SHOW
Home / Vol. 34, No. 4 (2010)

Larry Genge

Individual tip 2 of 2 from this reader’s published contribution.
Larry Genge, Glovertown, Newfoundland; ph 709 533-2798, [email protected]

“I got tired of the flimsy handles coming unscrewed on my imported drill press. The press had three short, thin screw-in handles that stuck out at an angle and provided no leverage. The handles pulled hard, and I couldn’t keep them tight because the threads often stripped where the handles were screwed on.

“To solve the problem I replaced the handles with a big 12-in. dia. wheel that came off a valve. The wheel has four l1 by 1/2-in. dia. metal handles welded on with knobs, scrounged from hydraulic control levers, friction-fitted to the ends. When using small bits with the drill press I just hold onto the wheel, but when using large bits I hold onto the handles to get more leverage. The improvement in the way my drill press handles now is beyond belief.”

Reproduced from the published FARM SHOW entry. Prices, coupons, availability and contact details are historical, not current offers. Reader methods are not universal instructions: follow manufacturer guidance, proper supports and safety practices, and consult a qualified professional when needed.

Comments and votes

Have you tried this idea? Mark it helpful and share how it worked in your shop.