Practical ideas from FARM SHOW MagazineSubscribe · Free issue · Send us your shop tip
Subscribe to FARM SHOW
Home / Vol. 34, No. 5 (2010)

Pete Captein

Pete Captein, Ontario, Ore.

“I was never able to justify the cost of a big shop press so I built my own. It’s about 14 ft. high, 10 ft. wide and is made from 10-in. H-beams.

It sets on a 6-ft. wide base. The 8-in. dia. cylinder is off an old Michigan payloader and is made so I can roll back and forth on the table, anywhere I want. It can handle very big jobs.

“The payloader’s other cylinder is mounted off to the side where I use it to pull things apart. It hangs from a steel beam near the shop’s ceiling. I’ve used it to pull a pto apart, to straighten out a silage truck’s door, and to straighten a bent T-ring on snap-on dual wheels.

“Both cylinders are powered by a 10 hp electric hydraulic power unit with two control valves, one for the main pressing cylinder and one for the pulling cylinder.

“A commercial shop press of comparable capacity sells for $20,000 or more. I spent less than $1,000.”

Reproduced from the published FARM SHOW entry. Prices, coupons, availability and contact details are historical, not current offers. Reader methods are not universal instructions: follow manufacturer guidance, proper supports and safety practices, and consult a qualified professional when needed.

Comments and votes

Have you tried this idea? Mark it helpful and share how it worked in your shop.