Practical ideas from FARM SHOW MagazineSubscribe · Free issue · Send us your shop tip
Subscribe to FARM SHOW
Home / Vol. 35, No. 3 (2011)

Pickup-Mounted Metal Bender

Featured source: Warren Farley

Warren Farley didn’t have enough room in his small garage for a stationary metal bender, so he built one that fits into the receiver hitch on back of his pickup. The unit consists of a 4-in. sq. vertical steel tube welded to two 12-in. sq. metal plates and uses four 18-in. long arms and a 36-in. long handle at the end to do the bending. A 4-bolt, adjustable clamp on the tube attaches to an adjustable hitch plate on the pickup. He used 3/4-in. thick, 2-in. wide steel to build the arms and drilled 5/8-in. dia. holes through them, which accept grade 5 bolts that hold the arms together.

“I built it after I bought a small stationary metal bender from Harbor Freight. It only cost $80 but couldn’t even bend 2-in. material,” says Farley.

“I ended up spending nearly 4 times that to build my bender, but it’s portable and is built a lot heavier. It’ll bend steel up to 3 in. wide and 3/8 in. thick, or maybe thicker, and with the long handle, it’s very easy to use.

“It weighs about 200 lbs. so I use a small 2-wheeled cart to move it around. It’s all I can do to lift it into the back of my pickup.” Contact: FARM SHOW Followup, Warren Farley, 280 State Street, Jackson, Ohio 45640 ([email protected]).

Reproduced from the published FARM SHOW entry. Prices, coupons, availability and contact details are historical, not current offers. Reader methods are not universal instructions: follow manufacturer guidance, proper supports and safety practices, and consult a qualified professional when needed.

Comments and votes

Have you tried this idea? Mark it helpful and share how it worked in your shop.