Practical ideas from FARM SHOW MagazineSubscribe · Free issue · Send us your shop tip
Subscribe to FARM SHOW
Home / Vol. 36, No. 4 (2012)

Robert McMahon

Individual tip 2 of 2 from this reader’s published contribution.
Robert McMahon, Knoxville, Tenn.

“I came up with a method to drill 1/2 in. or larger holes in steel pieces that I could not bring to my drill. I had previously had problems breaking large, expensive bits. Now I use bimetal hole saws in a hand drill. I first make a guide plate out of a scrap piece of plate steel with a hole drilled in it. Then I clamp or tack weld the plate where I want to drill the hole.

“I recently had to drill 5/8-in. holes in the frame of a tractor to mount a backhoe. Removal of the frame members would have taken half a day. Instead I clamped a guide plate to the frame and cut the holes with a 1/2-in. pneumatic wrench (I remove the holesaw mandrell drill bit so I can drive it with an impact wrench). I had perfect holes cut in minutes. Sometimes I use the guide plate to enlarge a hole, or to enlarge worn holes in bucket teeth mounts. I use a liberal amount of cutting fluid when cutting with holesaws.”

Reproduced from the published FARM SHOW entry. Prices, coupons, availability and contact details are historical, not current offers. Reader methods are not universal instructions: follow manufacturer guidance, proper supports and safety practices, and consult a qualified professional when needed.

Comments and votes

Have you tried this idea? Mark it helpful and share how it worked in your shop.