Practical ideas from FARM SHOW MagazineSubscribe · Free issue · Send us your shop tip
Subscribe to FARM SHOW
Home / Vol. 36, No. 4 (2012)

Low-Cost Filter Cleans Shop Air

Featured source:

When Noah Hubbard picked up some surplus wall cabinets, he had a brainstorm that he could use one to pull dust from his shop/garage.

“When I parked my car in the shop, it would get covered with a film of dust,” recalls Hubbard.

“Some of it was probably ash from the wood burning stove. Now I can park it in there for days, and it stays clean.” Hubbard cut out the back side of a cabinet. He then framed the front and back so each would accept two 16 by 25-in. furnace filters. At one end, he installed a small squirrel cage fan. The 1/20 hp motor can run steady for hours, pulling shop air through the filters.

“It pulls a lot of air through,” says Hubbard.

“I angle the discharge on it at the ceiling to help circulate air.” Hubbard says he changes the filters with the seasons. Contact: FARM SHOW Followup, Hubbard Rapid Tool LLC, 5558 West 800 North, Michigan City, Ind. 46360 (ph 219 874-1028; [email protected]; www.hubbardrapidtool.com).

Reproduced from the published FARM SHOW entry. Prices, coupons, availability and contact details are historical, not current offers. Reader methods are not universal instructions: follow manufacturer guidance, proper supports and safety practices, and consult a qualified professional when needed.

Comments and votes

Have you tried this idea? Mark it helpful and share how it worked in your shop.