Practical ideas from FARM SHOW MagazineSubscribe · Free issue · Send us your shop tip
Subscribe to FARM SHOW
Home / Vol. 37, No. 4 (2013)

Chad Travis

Chad Travis, Drasco, Ark.

“I made a wheeled bucket stand for a local auto garage. It’s designed to support a 5-gal. bucket of fluid 3 1/2 ft. off the floor, which makes pumping fluid into gearcases a much easier job when the vehicle is up on a lift. One person can hold the hose in the gearcase fill hole and pump in fluid, without having to reach down to the floor.

“The stand’s center support is made from a 2-ft. length of pipe welded to an angle iron base. The bucket rests in a tray made from 1-in. angle iron and 10-ga. sheet metal. The back support is made from 1/4 by 1-in. flat strap bent in a half circle.

“You just roll it under the vehicle. The raised stand makes the bucket much easier to reach than if it was on the floor.”

Reproduced from the published FARM SHOW entry. Prices, coupons, availability and contact details are historical, not current offers. Reader methods are not universal instructions: follow manufacturer guidance, proper supports and safety practices, and consult a qualified professional when needed.

Comments and votes

Have you tried this idea? Mark it helpful and share how it worked in your shop.