Practical ideas from FARM SHOW MagazineSubscribe · Free issue · Send us your shop tip
Subscribe to FARM SHOW
Home / Vol. 38, No. 5 (2014)

Daniel and Frances Huppert

Daniel and Frances Huppert, River Falls, Wis.

Their Deere 318D skid loader has a small toolbox located under the seat in the cab. However, the toolbox is too small and hard to reach. So Dan decided to attach a toolbox to the upper part of both loader arms.

“It puts my tools outside the skid loader where they’re easier to reach,” says Dan. He bought two 15-in. toolboxes, as well as a 1/4-in. thick rubber mat, 2 snap pins, and four 1/4 by 3/8-in. hard steel bolts. He welded 2 bolts to the upper part of each arm, using the toolbox to measure where they should go. He cut two 3 by 4-in. rubber mats for each arm and bolted them on.

“The mat makes a good surface to set the toolboxes on,” says Dan. He measured and drilled 1/4-in. holes in the toolboxes to match the bolts, then set the toolboxes over the bolts and onto the mats.

Next, he cut two 6 by 15-in. mats and set one mat inside each toolbox. The mats keep the tools from sliding around. He also attached a snap pin to each toolbox latch to keep the toolboxes from accidentally opening up while operating the skid loader.

Reproduced from the published FARM SHOW entry. Prices, coupons, availability and contact details are historical, not current offers. Reader methods are not universal instructions: follow manufacturer guidance, proper supports and safety practices, and consult a qualified professional when needed.

Comments and votes

Have you tried this idea? Mark it helpful and share how it worked in your shop.