Practical ideas from FARM SHOW MagazineSubscribe · Free issue · Send us your shop tip
Subscribe to FARM SHOW
Home / Vol. 39, No. 3 (2015)

Bob Moty

Bob Moty, Crystal Lake, Ill.

“I was a welder for 35 years and invented and/or made many things. Before I spray painted any of the pieces I built, I used the following process to keep the paint from peeling.

“After welding I would first scrape off the weld spatter, then wipe it down with lacquer thinner or a similar solution to remove the oil and grease. Then I used a gas torch to ‘sweat’ the metal. To see what I mean, take a gas torch and slowly move it across some clean, unpainted metal, and you’ll see the moisture come to the surface and evaporate ahead of the flame.

“When you’re finished, the metal should be lukewarm but not hot, to the point that you can lay your bare hand on it comfortably for about 5 seconds. Then spray paint it immediately, and you’ll never have a problem with paint peeling again.”

Reproduced from the published FARM SHOW entry. Prices, coupons, availability and contact details are historical, not current offers. Reader methods are not universal instructions: follow manufacturer guidance, proper supports and safety practices, and consult a qualified professional when needed.

Comments and votes

Have you tried this idea? Mark it helpful and share how it worked in your shop.