Practical ideas from FARM SHOW MagazineSubscribe · Free issue · Send us your shop tip
Subscribe to FARM SHOW
Home / Vol. 42, No. 3 (2018)

How To Make A Low Cost Temporary Table Saw

By By Mark Newhall, Editor
Featured source: Paul Tierney

My friend Paul Tierney, Bloomington, Minn., is a jack-of-all-trades who can do everything from artistic metalwork to sculptures to remodeling. He recently took on a rush job helping a client remodel a small restaurant and bar. The job called for ripping a big pile of cedar planking but he didn’t want to haul his table saw down to the job, and he didn’t want to haul the cedar back to his shop. So he came up with an idea for a temporary table saw. He took a sheet of plywood and cut a slot into it with his hand-held circular saw. Then he set the saw flat over the slot with the blade sticking through it and bolted the saw’s baseplate to the plywood with four countersunk bolts. Then he flipped the plywood over so the blade extends out the top. To keep the saw running continuously, Paul wrapped a metal bracket around the trigger and made a small wood wedge that slips under the bracket to apply pressure to the trigger. When he wants to stop the saw, he just pulls out the wedge. On top of the table he used spring clamps to hold a saw guide in place. And he drew measured gauge lines on top of the table so it’s easy to rip the cedar at different widths.

“It was a good solution to a short-term problem. The saw held up just fine to a bunch of cutting,” says Paul. Contact: FARM SHOW Followup, Paul Tierney, 10020 Pleasant Ave. S., Bloomington, Minn. 55420 (www.pauletierney.com).

Reproduced from the published FARM SHOW entry. Prices, coupons, availability and contact details are historical, not current offers. Reader methods are not universal instructions: follow manufacturer guidance, proper supports and safety practices, and consult a qualified professional when needed.

Comments and votes

Have you tried this idea? Mark it helpful and share how it worked in your shop.