“When my Suburban died, I didn’t know if it was an electrical or fuel problem. So, I took the air cleaner off and had someone try to start it while I held a propane weed burner over the throttle body inlet, letting it release propane. When the engine started, I let it run a little, then I cut the propane off, and the engine died. So, I figured out it was a bad fuel pump.
“Suburban fuel tanks are hard to install because you need to reach above and make all the connections before lifting it back in place. There is a lot of potential for stressed connections that you won’t know are damaged or leaking until the tank is back in place. So instead of that, I took up the carpet in the cargo area of the Suburban, and after I pulled the fuel tank, I determined how big an access panel I’d need to make to check all of the connections on the top of the tank. After making sure no electrical or fuel lines were in the way of the cuts, I cut out a rectangular access in the steel floor. It made connecting the fuel line and electrical connectors much easier. I patched up the floor by using sheet metal strips to support the patch, securing them with short self-tapping screws, then ‘siliconed’ the gap where the cuts were made.
Reproduced from the published FARM SHOW entry. Prices, coupons, availability and contact details are historical, not current offers. Reader methods are not universal instructions: follow manufacturer guidance, proper supports and safety practices, and consult a qualified professional when needed.
Comments and votes
Have you tried this idea? Mark it helpful and share how it worked in your shop.