
“Most of the things in my shop are on wheels so I can move them around as needed to make room for projects. However, some have only two wheels and can be quite heavy to pick up and move. I built a little mover to help. I just tip the top of the mover under the item’s edge and tip back to lift it off the floor.
“I built the mover out of some 1/2-in. pipe, some fittings, and a very short length of 1-in. aluminum channel for the lifter.
“The axle is 5/16-in. threaded (ready) rod inside a 4-in. length of pipe. A nut at either end of the pipe stabilizes the ready rod. Wheels from a Razor rider are mounted to the ends of the threaded rod. I used the Razor wheels because they have heavy-duty ball bearings.
“A 1/2-in. fitting welded to the top of the axle is the seat for the aluminum channel nipple. A 30-in. length of pipe welded to the axle at a 45-degree angle serves as a handle.
“I drilled and threaded the U-shaped lifter for a 5/16-in. bolt, which I drove into a short length of 1/2-in. pipe.
“To mount the lifter on the mover, I thread the pipe with the nipple into the fitting until it is almost tight. This lets the lifter pivot with the load when I turn the wheels.
“If I want a taller lifter, I use a longer length of pipe and bolt. I’m still experimenting with different materials for the top piece.”
Reproduced from the published FARM SHOW entry. Prices, coupons, availability and contact details are historical, not current offers. Reader methods are not universal instructions: follow manufacturer guidance, proper supports and safety practices, and consult a qualified professional when needed.
Comments and votes
Have you tried this idea? Mark it helpful and share how it worked in your shop.