Practical ideas from FARM SHOW MagazineSubscribe · Free issue · Send us your shop tip
Subscribe to FARM SHOW
Home / Vol. 20, No. 1 (1996)

Howard L. Hutton

Howard L. Hutton, Norton, Texas

“One fairly tough repair I made was replacing the rear engine main seal and clutch in a 1980 Deere 4840 tractor. I first made a stand to support the engine portion of the tractor, mounting large bearings for wheels on a frame made with 1 1/4-in. threaded rod that makes it easy to raise or lower the engine half of the tractor. We installed three hydraulic jacks under the back half of the tractor and then securely blocked the rear wheels in the front and back and on both sides so they could not move in any direction. Then we rolled the front half of the tractor forward about 3 ft. and did the work. We then pushed the two halves back together. We only had to push the front half to the side about 1/2 in. to get a perfect fit. We then put the bolts back in place with no other adjustment. Works fine and we saved a lot of money.”

Reproduced from the published FARM SHOW entry. Prices, coupons, availability and contact details are historical, not current offers. Reader methods are not universal instructions: follow manufacturer guidance, proper supports and safety practices, and consult a qualified professional when needed.

Comments and votes

Have you tried this idea? Mark it helpful and share how it worked in your shop.