Practical ideas from FARM SHOW MagazineSubscribe · Free issue · Send us your shop tip
Subscribe to FARM SHOW
Home / Vol. 20, No. 6 (1996)

Roger Baldwin

Roger Baldwin, Rock Rapids, Iowa

Back in the early 1960’s, before the advent of portable AC welders, Roger built a DC welder from a 32-volt generator out of a surplus WW II airplane.

“I ordered one from a surplus depot after seeing an ad in a magazine about making such a welder,” says the retired Lyon County extension agent.

“The generator had a short shaft with a spline on one end. I found a driveshaft with spline that matched it at an auto junk yard. I shortened that shaft and welded a knuckle onto it so it would match the pto shaft on our early 1940’s Allis Chalmers B. I wired welding cables into the outlets where the generator’s wires had been. I mounted the welder on a two-wheel trailer I pulled behind the tractor to keep the two shafts from vibrating apart. Then I just started the tractor and instantly had a welder. It worked beautifully.”

Reproduced from the published FARM SHOW entry. Prices, coupons, availability and contact details are historical, not current offers. Reader methods are not universal instructions: follow manufacturer guidance, proper supports and safety practices, and consult a qualified professional when needed.

Comments and votes

Have you tried this idea? Mark it helpful and share how it worked in your shop.