“I was installing wire leads to an arc welder and didn’t have any terminals on hand. Instead, I found some copper pipe about the diameter of the wire and cut off two pieces about 2 1/2 in. long. I flatened half of each piece and drilled a hole through the ends to bolt to the welder. I slipped the wire into the open end and soldered it in place. Worked just fine.”
Reproduced from the published FARM SHOW entry. Prices, coupons, availability and contact details are historical, not current offers. Reader methods are not universal instructions: follow manufacturer guidance, proper supports and safety practices, and consult a qualified professional when needed.
Comments and votes
Have you tried this idea? Mark it helpful and share how it worked in your shop.