Practical ideas from FARM SHOW MagazineSubscribe · Free issue · Send us your shop tip
Subscribe to FARM SHOW
Home / Vol. 21, No. 4 (1997)

Landis Shelton

Individual tip 2 of 3 from this reader’s published contribution.
Landis Shelton, Webbers Falls, Okla.

“When the bolt and bushing on the front spindle of my riding mower wore down, causing the spindle to flop around, I decided to fix the problem myself. I removed the bolt and bushing and used a 7/64-in. dia. drill bit to enlarge the bolt hole, then tapped it out and screwed in a 5/16-in. dia. bolt. Tightening up the bolt takes the slack out of the bushing and spindle. I also set a jamb nut on the bolt to keep it in place. It’s a simple but effective idea that I’ve since used on 1/2-ton, 1-ton, and 2-ton trucks. I think the same idea could be used on almost any vehicle. It’s not a permanent solution to the problem but it’ll keep a vehicle going for quite a while.

Reproduced from the published FARM SHOW entry. Prices, coupons, availability and contact details are historical, not current offers. Reader methods are not universal instructions: follow manufacturer guidance, proper supports and safety practices, and consult a qualified professional when needed.

Comments and votes

Have you tried this idea? Mark it helpful and share how it worked in your shop.