Practical ideas from FARM SHOW MagazineSubscribe · Free issue · Send us your shop tip
Subscribe to FARM SHOW
Home / Vol. 22, No. 2 (1998)

Henry A. Kubischta

Henry A. Kubischta, Dickinson, N. Dak.

The fuel tank on Henry’s late 1970’s 170 Allis-Chalmers tractor didn’t come equipped with a screen and that caused frequent headaches.

“The float from my sending unit deteriorated into pieces that were too little to get in the tank fitting but too large to go through the shutoff valve,” he says.

“Since there were no screens available, I built my own to save the time and trouble involved in taking the tank off the tractor, blowing it out and putting it back on.

“I took out the plug in the bottom of the tank and drilled and tapped a hole for a 1/4-in. dia. piece of brass pipe. I drilled about 50 tiny holes in three rows in the pipe, then capped one end and drilled about five holes in the cap, too. The pipe, which installs above the shut-off valve, extends up 2 in. inside the fuel tank and acts as a screen you can remove and clean by itself.

“Took about a half hour’s work and cost $1.00.”

Reproduced from the published FARM SHOW entry. Prices, coupons, availability and contact details are historical, not current offers. Reader methods are not universal instructions: follow manufacturer guidance, proper supports and safety practices, and consult a qualified professional when needed.

Comments and votes

Have you tried this idea? Mark it helpful and share how it worked in your shop.