Floyd has a 1983 International 5488 tractor that he equips with duals for pulling a field cultivator and harrows in spring.
The problem, Floyd says, is that the 20.8 by 38-in rear duals are difficult to remove with a 12-point socket wrench.
“It was a two-man job until I came up with this impact wrench-powered device that lets me take them off and put them on by myself. It consists of two long bolts that bolt to the wheel itself and extend out beyond the end of the axle. A head, made of two short pieces of pipe split down the middle lengthwise, goes over the end of the axle. A crossmember runs in line with the end of the axle on the bolts. At the center, there’s a threaded nut, and a 3/4-in. dia. piece of redi rod which serves as a driver. A bolt welded onto the redi rod lines up with the axle to slide the dual on or off depending on the direction you run the impact wrench, which fits over the bolt.
“It makes effortless work of an otherwise big job. Cost only about $20 to make.”
Reproduced from the published FARM SHOW entry. Prices, coupons, availability and contact details are historical, not current offers. Reader methods are not universal instructions: follow manufacturer guidance, proper supports and safety practices, and consult a qualified professional when needed.
Comments and votes
Have you tried this idea? Mark it helpful and share how it worked in your shop.