Practical ideas from FARM SHOW MagazineSubscribe · Free issue · Send us your shop tip
Subscribe to FARM SHOW
Home / Vol. 23, No. 4 (1999)

Dale Spoerl

Individual tip 2 of 2 from this reader’s published contribution.
Dale Spoerl, Elizabeth, Ill.

“I used scrap steel to make a 36-in. wide metal bender that lets me bend sheets of metal at a 90 degree angle. It’s equipped with a hinged handle on each side. I place the bender in a vise with the handles straight up in the air. Then I slip the metal sheet in under a bar and use a pair of vise grips to keep the sheet in place. To make the bend I simply pull both handles back toward me. I copied it off a photo of a commercial unit. It makes a nice clean 90 bend.”

Reproduced from the published FARM SHOW entry. Prices, coupons, availability and contact details are historical, not current offers. Reader methods are not universal instructions: follow manufacturer guidance, proper supports and safety practices, and consult a qualified professional when needed.

Comments and votes

Have you tried this idea? Mark it helpful and share how it worked in your shop.