“The traction clutch had been sticking on my ’93 Deere 5300 tractor, which I bought new. It has MFWD with a loader, low hours, and does only light duty. It’s always shedded.
The problem was it would stay in gear with the pedal pushed. The clutch would disengage as soon as I touched the brake. I adjusted the free travel, moved the seat closer, and checked the pedal for obstructions. I couldn’t spot the problem so I guessed that maybe the clutch springs weren’t able to slide the clutch plates apart on the shaft. It might be binding on the spline. Another possibility was that popping the clutch could put a slight twist on the splines.
“The pto shaft runs inside of the hollow traction shaft on this tractor. I bought a mirror and was able to peer into the clutch housing from the top. I couldn’t get light in there with even the smallest flashlight so I got the idea of lowering a single Christmas tree bulb into the inspection hole. Then I could clearly see the driveshaft splines. I pushed in the clutch and saw the splines get covered with about 1/4-in. of movement.
“So I slid a small clear tube into the hole right up to the spline and sprayed in a bit of WD40. I could see it hit the target. I jacked up one tire, turned the shaft, and sprayed again. No more sticking for the past month since I did that.
“The Deere mechanic I talked to had wanted to split the tractor apart to access the clutch.”
Reproduced from the published FARM SHOW entry. Prices, coupons, availability and contact details are historical, not current offers. Reader methods are not universal instructions: follow manufacturer guidance, proper supports and safety practices, and consult a qualified professional when needed.
Comments and votes
Have you tried this idea? Mark it helpful and share how it worked in your shop.