Dave and Doug Miller find changing oil in cars, trucks and tractors more convenient and less messy since they made a portable oil drain tank.
The father-son team operates Miller Golden Acres near Donnybrook, North Dakota.
When they put up a new shop building recently, they installed a vehicle lift. To change oil, Doug converted an old 15-gal. water pressure tank into the oil drain tank by first cutting it open and removing the air bladder. Then he welded it back tight and added four casters to the bottom so it could be moved around easily.
On top of the tank, he cut a couple of holes - on in the center and one to the side - and welded short lengths of 1 1/2-in. steel pipe into them.
“Both pipes are threaded on the outside end so I could put valves on them,” he says.
The center pipe is the main drain and is fitted with a telescoping drain pan that he made by inserting a piece of 1 1/4-in. dia. pipe (attached to the bottom of the pan) inside a piece of 1 1/2-in. dia. tubing. He drilled a hole in the 1 1/2-in. pipe near the upper end, threaded it, and put in a bolt for a set screw so he could lock the drain pan in place.
His drain pan is made of an old disk blade. To keep oil from slopping over the edge of the disk blade, he fastened a 4-in. wide piece of rubber around the edge.
“I welded a half in. rim around the outside edge of the disk blade and pop-riveted the rubber strip to that. Then I sealed it up on the inside with silicone so oil won’t leak out,” he says.
Finally, he added a flexible hose to the bottom of the tank to drain it out and an air inlet near the top.
“I use a small amount of pressure to empty the tank into a larger used oil barrel in the shop,” he says.
“It’s easier and less messy than trying to pour oil out of one container into another.”
Contact: Farm Show Followup, Doug Miller, Miller Golden Acres, 32400 380th St. NW, Donnybrook, N. Dak. 58734 (ph 701 482-7873; E-mail: [email protected]).
Reproduced from the published FARM SHOW entry. Prices, coupons, availability and contact details are historical, not current offers. Reader methods are not universal instructions: follow manufacturer guidance, proper supports and safety practices, and consult a qualified professional when needed.
Comments and votes
Have you tried this idea? Mark it helpful and share how it worked in your shop.