Practical ideas from FARM SHOW MagazineSubscribe · Free issue · Send us your shop tip
Subscribe to FARM SHOW
Home / Vol. 25, No. 5 (2001)

Vic Stratman

Vic Stratman, Argyle, Mo.

“The tie rod ends on my Deere 2440 tractor are built in Continued from previous page three sections. The outside section slides into a sleeve and clamps on. When they get worn, they’re very hard to get out. The inner end screws on over the center sleeve so I took a chop saw and cut that end off and welded a 5/8-in. nut onto it. Then I screwed a 5/8-in. threaded rod through the nut and to push out the outside tie rod end. It worked great and saved a lot of time.”

Reproduced from the published FARM SHOW entry. Prices, coupons, availability and contact details are historical, not current offers. Reader methods are not universal instructions: follow manufacturer guidance, proper supports and safety practices, and consult a qualified professional when needed.

Comments and votes

Have you tried this idea? Mark it helpful and share how it worked in your shop.