Practical ideas from FARM SHOW MagazineSubscribe · Free issue · Send us your shop tip
Subscribe to FARM SHOW
Home / Vol. 26, No. 1 (2002)

“Panel Clamps” Help Make Better Butt Welds

Featured source:
“Panel Clamps” Help Make Better Butt Welds
Photo: FARM SHOW · Vol. 26, No. 1 (2002) · p. 41

You can do a better job welding sheet metal with these “panel clamps”, according to the manufacturer who says they make butt welds easier by holding loose edges tightly together.

Panel Clamps are designed to be used on mild steel or aluminum with thicknesses between 18 and 24 ga. Made of non-corroding aluminum and stainless steel, the unit holds the edges together while you tack weld them together. Once the clamp is off you can finish the welding.

“It works great for patching in replacement panels and for repairing cracks, and allows you to make a butt weld that water can’t penetrate,” says Scott Brittin, BHP Products, Inc., Katy, Texas.

A set of five Panel Clamps sells for $39.95 plus $4 S&H.

Contact: FARM SHOW Followup, BHP Products, Inc., 23 Lakefield Tris, Katy, Texas 77493 (ph 800 480-3951; fax 281 391-1249).

Reproduced from the published FARM SHOW entry. Prices, coupons, availability and contact details are historical, not current offers. Reader methods are not universal instructions: follow manufacturer guidance, proper supports and safety practices, and consult a qualified professional when needed.

Comments and votes

Have you tried this idea? Mark it helpful and share how it worked in your shop.