“I stripped out a thread where the flywheel bolts onto the crankshaft of an engine which was already assembled. I certainly didn’t want to have to pull out the engine again in order to fix the (Continued on next page) (continued from previous page) threads, but I was concerned about tapping a thread insert into the hub without a proper alignment tool. I tried to tap it by freehand but wasn’t able to get the tap to start properly.
“To solve the problem, I took a piece of wood from a 2 by 4 and made a guide bushing out of it by drilling it to the tap drill size on my drill press. I also located and put two additional holes in it to bolt it to the hub. I drilled the stripped hole with the proper tap drill for the insert, using the wood block to guide it. Then I tapped it with the wood block in place, which guided and propelled the tap forward to make a perfectly tapped hole in the hub. This method can be used for any stripped out hole where a piece of wood can be bolted or clamped over it.”
Reproduced from the published FARM SHOW entry. Prices, coupons, availability and contact details are historical, not current offers. Reader methods are not universal instructions: follow manufacturer guidance, proper supports and safety practices, and consult a qualified professional when needed.
Comments and votes
Have you tried this idea? Mark it helpful and share how it worked in your shop.