Practical ideas from FARM SHOW MagazineSubscribe · Free issue · Send us your shop tip
Subscribe to FARM SHOW
Home / Vol. 28, No. 1 (2004)

Air-Powered Shop Hoist

Featured source:

“It’s lightweight and much easier to use than hydraulic lifts and can be built a lot cheaper,” says Bruce Graham, Tyler, Texas, about his air-powered shop hoist.

A pair of air shocks are used to move the lift arm up and down. Air pressure is supplied by an on-board air compressor equipped with an electrical solenoid valve. The compressor motor runs off a battery that mounts on the frame. A non-powered hydraulic cylinder is used to lock the load into any position. A battery gauge and air pressure gauge mount just above the motor.

“I’ve used this unit in my shop for more than eight years and really like it,” says Gra-ham.

“I got the idea after the engine in my friend’s 4-WD pickup developed a valve train problem and we had to remove the cylinder heads. We put it together for that job and found it was a lot easier to use than a con-ventional hoist.”

The hoist can lift up to 150 lbs. Contact: FARM SHOW Followup, Bruce Graham, 13801 Eastside Road, Tyler, Texas 75707 (ph 903 566-1248; email: [email protected]).

Reproduced from the published FARM SHOW entry. Prices, coupons, availability and contact details are historical, not current offers. Reader methods are not universal instructions: follow manufacturer guidance, proper supports and safety practices, and consult a qualified professional when needed.

Comments and votes

Have you tried this idea? Mark it helpful and share how it worked in your shop.