“I bought a 4-ft. pull-type rotary brush mower in the early 1960’s. I didn’t have an over-running clutch for the pto, so once the mower got up to speed it drove the rear wheels as long as the transmission on my Farmall B was in gear. The inertia of the mower could drive you up a tree. Besides being hard to operate, it was too long to maneuver in our woodlot.
“Belly mount was the obvious solution, but that complicated the power train. No one at that time had any confidence that hydraulics would drive the mower except me, so I did it anyway. I bought a pair of 22 gpm Gresen gear pump/motors that fit on the drive shafts. I had a local blacksmith build a 20-gal. tank with valves attached to the top and axle mounts on the bottom. I reversed the trailing mower so the tractor drawbar pushed rather than pulled the mower. Two hydraulic cylinders on the clutch housing of the tractor provide lift. I added a one-way hydraulic valve to the mower motor for over-running.”
Reproduced from the published FARM SHOW entry. Prices, coupons, availability and contact details are historical, not current offers. Reader methods are not universal instructions: follow manufacturer guidance, proper supports and safety practices, and consult a qualified professional when needed.
Comments and votes
Have you tried this idea? Mark it helpful and share how it worked in your shop.