Practical ideas from FARM SHOW MagazineSubscribe · Free issue · Send us your shop tip
Subscribe to FARM SHOW
Home / Vol. 28, No. 6 (2004)

George Wissinger

George Wissinger, Huntington, Ind.

He fixed a common problem on his 1963 New Holland 268 small square baler.

“It’s not unusual in that line of balers for the belt to slip on the pickup when you’re in heavy hay or long stubble,” he explains.

“I found a simple modification that I was able to make in an hour and a half after I got the parts.”

He removed the belt drive (V-belt and the V-belt pulley) from the pickup and replaced it with sprockets and no. 2040 roller chain. He installed the two sprockets he bought at a parts store with two “Weld-a-Hubs.”

“I welded a 1 by 2-in. piece of scrap iron to the hub, and drilled a hole through this tab, and also the sprocket. Then I put in a 1 by 2 by 1/4-in. thick shear bolt for protection. If something happens to the pickup, it will shear the bolt. In the 20 years since I made the modification, I’ve only sheared two bolts. It’s a totally different performing machine.”

Wissinger says the job was quick because he only had to weld one sprocket. The other sprocket is driven by the tab with the 1/4-in. bolt in it. The more positive drive to the pickup gives the baler more capacity.

“I’ve done three of these balers – mine and two others in the neighborhood. People were so impressed with mine that they wanted it on theirs, too,” he says.

Reproduced from the published FARM SHOW entry. Prices, coupons, availability and contact details are historical, not current offers. Reader methods are not universal instructions: follow manufacturer guidance, proper supports and safety practices, and consult a qualified professional when needed.

Comments and votes

Have you tried this idea? Mark it helpful and share how it worked in your shop.