Practical ideas from FARM SHOW MagazineSubscribe · Free issue · Send us your shop tip
Subscribe to FARM SHOW
Home / Vol. 30, No. 4 (2006)

Bob Moty

Bob Moty, Crystal Lake, Ill.
Bob Moty
Photo: FARM SHOW · Vol. 30, No. 4 (2006) · p. 36

“I used 1/ 4-in. pegboard to make a tool board for use at home. To make box/open end wrench holders I cut off the heads on some 1/4 by 2-in. bolts, then bent 1/4 in. of the end of each bolt at a 90 degree angle and used ‘whiz nuts’ at the front and rear. Nuts and flat washers would also work. To make socket holders, I cut off 1/4 - 3/8-in. and 1/2-in. bolts and rounded the ends, then drilled holes in lengths of 1 1/4 by 1 1/4 by 1/8-in. thick angle iron and welded in the bolts. I like this system because all my tools are arranged by size and are always in full view.

“One side of the pegboard is for standard wrenches, and the other side is for metric.”

Reproduced from the published FARM SHOW entry. Prices, coupons, availability and contact details are historical, not current offers. Reader methods are not universal instructions: follow manufacturer guidance, proper supports and safety practices, and consult a qualified professional when needed.

Comments and votes

Have you tried this idea? Mark it helpful and share how it worked in your shop.