Practical ideas from FARM SHOW MagazineSubscribe · Free issue · Send us your shop tip
Subscribe to FARM SHOW
Home / Vol. 30, No. 5 (2006)

Bob Bugger

Individual tip 1 of 2 from this reader’s published contribution.
Bob Bugger, Effingham, Ill.

Bob reduced wire changing time on his mig welder by installing an extra spool dispenser that he designed himself.

In the past, he had to wind wire from larger wheels onto the smaller wheel that comes with the welder. To eliminate that step, he mounted a bracket in the unused space below the welder. The bracket is simply a piece of flat angle iron with a short shaft to allow the commercial spool to slip on. In the bottom of the upper compartment, he installed a small brass fitting to allow the wire to slip through smoothly without jamming.

Reproduced from the published FARM SHOW entry. Prices, coupons, availability and contact details are historical, not current offers. Reader methods are not universal instructions: follow manufacturer guidance, proper supports and safety practices, and consult a qualified professional when needed.

Comments and votes

Have you tried this idea? Mark it helpful and share how it worked in your shop.